I would love to know why my printer developed those wavy patterns.

If anyone has an idea, i am all ears!

#3dprinting #functional3dprint

Needed some new ceiling vents for the basement to replace some old bulky and discoloured ones I installed years ago (after one fell out!). New store bought ones are $20+ a piece and still look bulky and ugly, so designed and printed some custom flush mount vents instead for <$1and they look awesome.

#3dprinting #functional3DPrint #functionalprint #homedecor #diy
#autodeskfusion #orcaslicer

The two pieces of version two of my Starlet coolant overflow tank cap both came out really well, though the difference between 0.050mm resin layers and 0.20mm fff layers is very visible up close. I'm not sure what my best technique for attaching the ABS hose barbs to the flexi-resin (Siraya Tenacious) will be, but I've designed it so I can make the ABS piece clamp to the resin if I can't find a good adhesive that can hold the two together.

My PC filament arrived today, so I'm gonna do some testing to make sure my printer can actually *hold* a highish chamber temp before I start working on calibration prints.

#3dPrinting #Functional3dPrint #ABS #Resin3dPrinting

Alright, well, following the critical flaw in my plan pointed out by @teotwaki (thank you again, I cannot believe I didn't think about fibers escaping) I'm gonna go ahead and try PC for the plug I'm printing for my friend's transmission, though I've also just discovered that the original is ABS, so I'll probably print one in ABS too then figure out which is better after some testing.

#3dPrinting #Functional3dPrint #Plastic #Polycarbonate #Polyamide #CarbonFiber #AcrylonitrileButadieneStyrene

I have a 3d printing materials question for anyone who might have an answer:

Are there any particular oddities/"preferences" that pa12-cf has when printing?

I decided to go with pa12 (nylon) for its chemical and heat resistance because Im almost done designing a plug for a friend's car and its going to be in constant contact with their transmission and will likely have gear oil in contact with some surfaces.

Id also accept advice on a different material to use.

#3dPrinting #Functional3dPrint #Nylon #pa12

Gridfinity's default size perfecly matches Ikea Alex. Coincidence? 🤔

#ikea #hack #diy #alex #gridfinity #storage #Functional3DPrint

Gunpla Storage Post

This is the expanded version of my 3D printed Multiboard display for my model kits. All but 3 of my assembled kits are up there. It's a bit chaotic, but I definitely have more available wall space than floor space.

@gunpla

#gunpla #modelkits #Functional3DPrint #multiboard #3Dprinted

What a time to be alive ✨

#Functional3DPrint #3dprint

There's still some finishing work to do, but im quite happy with how the new faceplate for my van's auxiliary air valve came out.

If Id printed it the other way around (face up instead of face down) the gasket surface wouldnt need any real cleanup, but it wouldve added a ton of supports and my nfep is nearly worn out (I find supports stress it far more than large faces). 2 minutes of sanding isn't that big of a deal.

#3dPrinting #ResinPrinting #Functional3dPrint #ToyotaVan