Anyone else experiencing this file list flicker in the #PrusaLink webinterface when behind an #nginx reverse proxy?

https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/4549

#3dPrinting #nixos #prusa

Looks like our #PrusaMINI killed itself. It does turn on but gets very hot and the USB flash drive is not recognized anymore. Didn't do anything fancy, just used #PrusaLink to start a print.

Ordered a replacement board, luckily <50€ 👍

#3dprinting #repair

Wouldn't it be cool if #PrusaLink (the webinterface served by #Prusa printers) would provide a way to configure a custom camera stream URL?

You can easily hack the HTML to do it, but it's served as a single compressed HTML page. I proxy it with #nginx for SSL / #LetsEncrypt encryption - I don't think nginx could modify the served decompressed HTML? 🤔

@josefprusa @prusaslicer

#3dPrinting

800 lines of  #nix later and I have successfully beefed up our #3dPrinting infrastructure at work @umphy with one #RaspberryPi 4:

· a https://gethomepage.dev landing page
· three fullHD webcams, one for each printer, with current filament visible
· a smart #Tasmota multiplug to remotely power off a printer in case of a problem/hangup
· 🐙 #OctoPrint for the Prusa MK3S, #PrusaLink by the #PrusaMINI​s
· 🔐 all password-protected and certs from #LetsEncrypt

#Prusa #NixOS

Finally got around to making my 3D printer wifi connected.

The annoying loop of finding the dongle, and running between the printer and computer when trying to perfect a print is finally history.

Prusa Link so far looks very nice. Have been considering OctoPrint for a while but decided to go with the official one directly on the einsy board.

Next up, adding the camera so I can monitor it from anywhere also.

#3dprint #prusa #prusalink