Here is the finished Squat Colossus.
I’ve taken the weathring further than I normally go, which was fun. The launching rocket option was just too tempting to not do.

The STL is from Gregsters Lab, avaiable on the Vanguard Miniatures site, the infantry, flyer and bikes are Grudd figures from Onslaught Miniatures.

#Epic40k #NetEpic #Squats #Grudd #BattleForGolgotha #PaintingMinis #Warmongers #Warmaidens #Warseers #3dPrintingMinis

The latest #3DPrintingMinis. Printed more of MZ4250's models for a future session of Storm Kings Thunder.

#DnD

I love him 🥺💕

#models #3DPrintingMinis #modelbuilding

A lot of them lost ears when I was pulling the supports off. Important lessons learned:

1. Was probably going overboard with supports
2. Need to remove supports before curing.

#3DPrintingMinis #3dprinting

I think the drow bladesinger print came out well. It’s probably the most significant remix I have done to date.

1. Swapped out the original head
2. Added elf ears to the new head
3. Replaced one of the arms with a prosthetic one
4. Slightly reshaped the chest area to make the body more feminine (the model I started with was male, apparently you cannot be a lady, a bladesinger, and a person who wears pants).

#3dprinting #dnd #3DPrintingMinis

This run had seven minis on it. Three failed (one of which had succeeded on a previous run) and four succeeded (or at least close enough to use).

#3dprinting #3DPrintingMinis

I don't know how it did it, but when I opened three pieces for a mini at once with #Meshmixer it figured out how to attach them correctly without any guidance from me. Fantastic!

#3DPrintingMinis #3dprint #3dprinting