Just submitted my serial request for the #voron 2.4. It is one month and a day since I submitted the request for the Voron 0. #3dprinting
| Printables | https://www.printables.com/social/432342-rad3d/models |
RAD 3d
@robdeloach
- 2 Followers
- 215 Following
- 50 Posts
Lots of hobbies like 3d printing, woodworking, photography, and tech. I like watching the Padres and all auto racing. #iracing #3dprinting #padres #tech #apple #photography #nascar #f1 #indycar
@elduvelle I didn't not that. But I was a bit surprised by how bad it was uncured. And it obviously won't work with the clear since it's a darker grey.
@elduvelle Some people mix in some Siraya Tech Tenacious to reduce brittleness. I've used it by itself and it is very stinky. Here is a discussion about ratios. https://www.reddit.com/r/resinprinting/comments/ysbmst/ideal_ratios_for_mixing_siraya_tech_tenacious/
@loop0 Thank you.
Just finished the #Voron 2.4 build today. It went pretty well except for configuring the touchscreen. #3DPrinting
@severedaffect Have you seen the Ellis Tuning Guide? It has some of what you're asking for. It's recommended often. https://ellis3dp.com/Print-Tuning-Guide/
@dave I just follow the #3dprinting hashtag so I see it in my home timeline. I also keep it in a column. From there you can decide to follow people.
Finally done with the #voron 0.2 build. I'm happy with how it turned out. #3dprinting
@mav I think you can just ask your question and tag it with the #3dprinting hashtag. Search is based on hashtags and you can follow hashtags that interest you.
@Stark9837 @wbradmoore @[email protected] Looks like it's effecting the second layer about the same.