Andro AbhiBackyard UFO Is Out of This World
#holidayhacks #microcontrollers #frigginlasers #rgbleds #smoke #teensy41 #ufo #hackaday
-- Delivered by RssEverything service
hackaday unofficialApple III Slows Down to Smell the Roses
The most collectible items in the realm of vintage computers often weren't the most popular of their era. Quite the opposite, in fact. Generally the more desireable systems were market failures when they first launched, and are now sought out because of a newly-appreciated quirk or simply because the fact that they weren't widely accepted means there's fewer of them. One of the retro computers falling into this category is the Apple III, which had fundamental hardware issues upon launch leading to a large recall and its overall commercial failure. [Ted] is trying to bring one of these devices back to life, though, by slowing its clock speed down to a crawl.
The CPU in these machines was a Synertek 6502 running at 1.8 MHz. With a machine that wouldn't boot, though, [Ted] replaced it with his own MCL65+, a purpose-built accelerator card based on the 600 MHz Teensy 4.1 microcontroller in order to debug the motherboard. The first problem was found in a ROM chip which prevented the computer loading anything from memory, but his solution wouldn't work at the system's higher clock speeds. To solve that problem [Ted] disabled the higher clock speed in hardware, restricting the system to 1 MHz and allowing it to finally boot.
So far there haven't been any issues running the computer at the slower speed, and it also helps keep the computer cooler and hopefully running longer as well, since the system won't get as hot or unstable. This isn't [Ted]'s first retrocomputing rodeo, either. His MCL chips have been featured in plenty of other computers like this Apple II which can run at a much faster rate than the original hardware thanks to the help of the modern microcontroller.
#retrocomputing #6502 #apple #appleiii #arduino #clockspeed #microcontroller #restoration #teensy41
Eight RS232 Ports, One Ethernet Port
When it comes to impromptu enclosures, [Paul Wallace] is a man after our own hearts, for his serial-to-Ethernet converters allowing him to control older test equipment were housed in takeaway curry containers. Once the test equipment pile had grown it became obvious that a pile of curry containers was a bit unwieldy, even if the curry had been enjoyable, so he set about creating an all-in-one multiway serial to Ethernet box.
Reminiscent of the serial terminal access controllers that were found in dumb terminal sites back in the day, it's a box with eight DB-9 connectors for serial ports and a single RJ45 Ethernet port. Inside is a Teensy 4.1 which packs a PHY and eight hardware serial ports, and a pile of MAX232 level converter modules. These have a small modification to wire in the CTS and RTS lines, and the whole is clothed in a custom 3D printed case.
The result is a very neat, almost commercial standard box that should save him quite a bit of space. Not everyone has eight devices to drive, so if you have just one how about using an ESP8266?
Teensy 4 Pushed to the Limit with 1 GHz Overclock
Do you need a microcontroller that runs at 1 GHz? No, probably not. But that didn't stop [Visual Micro] from trying, and the results are pretty interesting. Not only did the plucky little chip not cook itself, it actually seemed to run fairly well; with the already powerful microcontroller getting a considerable boost in performance.
According to [Visual Micro] the Teensy 4.1, which normally has its ARM Cortex-M7 clocked at 600 MHz, can run at up to 800 MHz without any additional cooling. But beyond that, you'll want to invite some extra surface area to the party. It's easy enough to cut a chunk out of an old CPU/GPU cooler and stick it on with a dab of thermal compound, but of course there's no shortage of commercially available heatsinks at this size that you could pick up cheap.
With the heatsink installed, [Visual Micro] shows the Teensy running at around 62 C during a benchmark. If that's a little hot for your liking, they also experimented with an old laptop cooler which knocked the chip down to an impressive 38 C while under load. It doesn't look like a particularly practical setup to us, but at least the option is there.
[Visual Micro] unfortunately doesn't go into a lot of detail about the benchmark results, but from what's shown, it appears the overclock netted considerable gains. A chart shows that in the time it took a stock Teensy to calculate 15.2 million prime numbers, the overclocked chip managed to blow through 21.1 million. The timescale for this test is not immediately clear, but the improvement is obvious.
Even at the stock 600 MHz, the Teensy 4 is a very powerful MCU. Especially after the 4.1 refresh brought in support for additional peripherals and more RAM. But we suppose some people are never satisfied. Got a project in mind that could benefit from an overclocked Teensy? We'd love to hear about it.
Thanks to [Zane] for the tip.
#microcontrollers #heatsink #laptopcooling #overclock #teensy4 #teensy41
Vintage Computers With a Real Turbo
In prior centuries, it was common practice to tie the operation of a program to a computer's clock speed. As computers got faster and faster, the programs tied to that slower clock speed sometimes had trouble running. To patch the issue temporarily, some computers in the early 90s included a "TURBO" button which actually slowed the computer's clock speed down in order to help older software run without breaking in often unpredictable ways. [Ted Fried] decided that he would turn this idea on its head, though, by essentially building a TURBO button into the hardware of old computers which would greatly increase the execution speed of these computers without causing software mayhem.
To accomplish this, he is running CPU emulators on Teensys (Teensies?), but they are configured to be a drop-in replacement for the physical CPU of several retro computers such as the Apple II, VIC-20, and Commodore 64 rather than an emulator for an entire system. It can be configured to run either in cycle-accurate mode, making it essentially identical to the computer's original hardware, or it can be placed into an accelerated mode to take advantage of the Teensy 4.1's 800 MHz processor, which is orders of magnitude faster than the original hardware. This allows (most of) the original hardware to still be used while running programs at wildly faster speeds without needing to worry about any programming hiccups due to the increased clock speed.
The video below demonstrates [Ted]'s creation running in an Apple II but he has several other cores for other retro computers. It's certainly a unique way to squeeze more computing power out of these antique machines. Some Apple II computers had a 4 MHz clock which seems incredibly slow by modern standards, so the 800 MHz Teensy would have been considered wizardry by the standards of the time, but believe it or not, it's actually necessary to go the other direction for some applications and slow this computer down to a 1 MHz crawl.
#retrocomputing #appleii #clock #cpu #emulator #fpga #speed #teensy41 #turbo
