Hyderabad joins PSL as seventh franchise

https://fed.brid.gy/r/https://dailytimes.com.pk/1431668/hyderabad-joins-psl-as-seventh-franchise/

PSL 2026 welcomes Hyderabad and Sialkot teams

https://fed.brid.gy/r/https://dailytimes.com.pk/1431663/psl-2026-welcomes-hyderabad-and-sialkot-teams/

PSL launches teams auctions in Islamabad as league expands to eight

https://fed.brid.gy/r/https://dailytimes.com.pk/1431648/psl-launches-teams-auction-in-islamabad-as-league-expands-to-eight/

Quản lý 3 startup? Robin chia sẻ công cụ Megadesk: AI chatbot hỗ trợ khách hàng, tạo lead, tích hợp Stripe, giảm tới 80% thời gian hỗ trợ. Dùng thử nhanh, không cần đăng ký, góp ý nhé! #startup #AI #chatbot #khách_hàng #lead #công_cụ #Megadesk #SaaS

https://www.reddit.com/r/SaaS/comments/1q78w7i/to_you_who_have_multiple_startups_how_do_you/

ISPR chief blames political-terror nexus for spike in KP terrorism

https://fed.brid.gy/r/https://dailytimes.com.pk/1430536/ispr-chief-blames-political-terror-nexus-for-spike-in-kp-terrorism/

My glider needs the center of gravity shifted aft, so I need to add weight in the tail.

The first photo is looking into the rudder cove (rudder removed). I can bolt some lead plates to the flat face of the vertical fin spar, but I will need even more weight added back here.

Note that the rudder hinge support is glowing green...a flashlight on the other side is illuminating it.

That part is hollow and it's nothing but dead space. I can add lead shot and epoxy in there.

The second photo shows the view of this pale green fiberglass part from the other side. Before I can add lead shot in there, I need to add a dam to retain it while the epoxy cures.

Third photo shows a piece of scrap Plexiglas that fits up against the end of the rudder hinge support.

Final photo shows the Plexiglas dam glued into place with RTV silicone caulk. It has a semicircular cutout that allows a larger diameter piece of tubing to be placed there while I pour lead shot and epoxy into a funnel and fill that empty space.

Half of the caulking work was done blind and by feel. I am accessing this tight space from the inspection port in the side of the vertical fin. There is just enough room for one hand and this part to pass through the port and then get positioned. I practiced before applying the caulk so I knew exactly how to position and twist the part so that I didn't make a mess and most of the caulk ended up in the desired location.

#AvGeek #Aviation #ElectricAircraft #Homebuilt #Glider #DIY #EAA #Epoxy #Ballast #Lead #Plexiglas

Sindh CM Murad Ali Shah orders crackdown on Karachi street crime

https://fed.brid.gy/r/https://dailytimes.com.pk/1428296/sindh-cm-murad-ali-shah-orders-crackdown-on-karachi-street-crime/