Ethan BlantonI made the mistake of updating my #homeassistant which made me update #zwavejs and now for some reason my Z-Wave devices, which zwave-js says are connected, show up as "not ready" in Home Assistant. And this is why I was happily running 2022.12. #HomeAutomation #WebDev #SoftwareSucks
Gorgeous na Shock!I've determined I need to once again split off my #ZWaveJS install to its own Raspberry Pi from the #HAOS Raspberry Pi so I can put #HomeAssistant into the Locked Closet while keeping the ZWave stick in range of all the ZWave stuff that doesn't play well with repeaters and now I have a vague sense of dread. 😩
Scott EllisUpgrade of my #zwave controller from 700 to 800 series was uneventful. #homeassistant +#ZWaveJS was just a matter of backing up and then restoring the NVM.
Well, I did have to go add USB ACM to my #linux kernel but that's my own fault for not using modules. 😁
Picked up an ATRIM #zwave 800 stick to try and replace my SIL 700 series one. It shipped with 7.17.2 firmware and refuses to take an upgrade in #ZWaveJS , throwing an update error after pushing the 4204D.gbl firmware file.
Any #homeassistant peeps have an idea?
Obviously, the 700 series stick upgrades just fine (running 7.21.2 on it now).
Brian May 🐧#homeassistant says "MQTT entity name starts with the device name in your config" for a lot for my #zwave devices. I have the latest zwave-js-ui #ZWaveJS installed (9.8.3). Is this something I need to be concerned about?
I see a lot about this message for zigbee, but nothing for zwave.
TubesZBTubesZW??? Almost, but not quite 😎
Kits are now available with everything you need for a PoE Z-Wave adaptor, everything but the radio that is. Due to the differing global frequencies and the z-wave certification process I have no desire to make a custom radio module. Instead the kits work with most Raspberry Pi GPIO Z-Wave modules. (Zooz 800 LR and Razzberry Pro 7 Tested)
Tykaynsi quelqu'un a déjà eu le prob avec #ZWaveJS UI et #domoticz je galère
https://easydomoticz.com/forum/viewtopic.php?p=116630&sid=998e2c23e68d9291e9debbd642dbdd7e#p116630
Unixorn - 90% Snark by weight@sstranger @andy_warb @zigbee @homeassistant
I haven't had speed issues with my sensors. I moved my zigbee from a huzbsb-1 to a conbee II so that I could run #zigbee2mqtt on a different HC2 than the one I run #zwavejs on. I run HA on a 3rd since I have several odroids I'm using as #moosefs chunkservers and don't need to jam them all into one machine.
A stronger mesh is always a good thing though.
Jeroen Franssen 🇧🇪IoT efforts going well these last days. Two smart thermostats, power meter, converted my #vera to #zwavejs & #zigbee2mqtt. Discovered via the @homeassistant energy panel the supercool AI on the edge project for reading gas, water and electricity meters. https://github.com/jomjol/AI-on-the-edge-device
Challenge accepted. First ESP32 already flashed, now the mechanical part of fixing it on my outside gas meter...
Challenge accepted. First ESP32 already flashed, now the mechanical part of fixing it on my outside gas meter...
