AilbheFittings are harder on a chair because it can't hold the pins for me while I fix things.
I'm tightening up around the... armscye? where the arms join the body and I will need to figure out how to keep the skirt tugged down firmly.
Matching the second ear was so easy! I've also updated the pattern for those pieces so that if I have to do this again I'm starting from a better place.
Next I'll join the arms to the wings in that wrinkly corner, then put the piping and fronts on the arms. And then it's hemming. #Sewing
The world is 86% pins
And this thing I'm sewing is technically a "loose" cover but I've just done up its zips and tugged it into place and it's not loose. It's form-fitting. It's a snug cover.
THAT'S IT
no more until September
I'm declaring Finishing Amnesty. The chair is covered, the ends are hemmed, I'm going to sit in it like this for at least two weeks before I take it off again. It's EXHAUSTING getting it on and off for fitting. #Sewing
Ok I have a to do list in order of importance:
Crutches caddy
Underwear
Dungarees
Only the dungarees, which are completely unnecessary, have any progress yet. #Sewing
Me in my grey pyjamas trying on my HUGE ORANGE DUNGAREES over the top.
I think I need to do some ironing next to get to the point of attaching the straps. And I think I understand smocking.
I've topstitched the yoke facing into place and it involved more ironing. Next is more basting, then putting away the body of the shirt and starting on the sleeves.
I have read the instructions for the continuous lap next to the cuffs and I strongly suspect them of being very "now draw the rest of the owl."
Last time I made a shirt, the collar confused me until I had finished it. This time, the sleeve end and cuff are extremely confusing so I hope they'll also become obvious as I plough through.
But I am afraid of the continuous lap. #Sewing
Today I have unpicked and rebasted one sleeve, fully stitched both sleeves, and unpicked both sets of basting.
Next is trimming half one side's seam allowance, ironing in the other side's, and stitching all THAT. So I'm not congratulating myself on my lack of puckering just yet.
Ailbhe (@[email protected])
Attached: 4 images The case of my 1940 Singer 201K handcranked sewing machine. The way the storage and case works is so, so simple and clever. #SewingMachine #Sewing
Trimmed seam, ironed seam, folded seam, pinned seam, ironed seam, basted seam, ironed seam, stitched seam (swearing elided for brevity).
The inside isn't great but the outside is fine. #Sewing
Ailbhe (@[email protected])
Cut out the fronts, back, and sleeves. Smaller bits tomorrow. Tired now.
#sewing #organisation
https://mastodon.art/@artbyailbhe/111053979534985785
Ailbhe (@[email protected])
Today's #sewing was ironing. Three metres of cotton shirting in preparation for making another from my McCall's pattern. This one will be longer and have sleeves, but will be of a reasonably civilised fabric, so that's exciting. The first one was made of extreeeeeeeemely slippery linen and was like sewing a teflon-coated octopus.
Ailbhe (@[email protected])
Attached: 1 image I finished the shirt. It's a little short so I'll make it longer in future, but it's GREAT. I'm so pleased with it. The linen is much too drapey and soft for the pattern but it's a functional garment and all the internal seams finished nicely so the wearer is almost completely unaware of the clo once clothed. #Sewing
Buttonholes on the Singer 201k with the Greist buttonholer are an absolute doddle. I'm not yet completely accurate with my starting point placement but everything else is just drinking tea and turning the handle.
https://mastodon.art/@artbyailbhe/110820830320708682
Ailbhe (@[email protected])
Attached: 3 images Today my Greist buttonholer arrived. It comes with five templates, a thingy to cover the feed dogs so that only the buttonholer will move the fabric, and a sense of simplicity and elegance. It's like a walking foot: when the shaft for the presser foot is screwed in place, the lever will fit over the screw that holds the needle in place, and the movement of the needle will operate the buttonholer mechanism. If kept oiled and free of rust, it will last forever. #Sewing #SewingMachine #Buttonhole
Mastodon•ART 🎨 CuratorPic 1: A work in progress denim bodice with floral embroidery on the front sides
Pic 2: the back of the bodice
Pau Amma@artbyailbhe
Is "waistcoat" the right name for this?
Left pic: "The front of a waistcoat in the making hanging down, made from blueish white fabric with floral embroidery."
Right pic: "The back of a waistcoat in the making hanging down, made from faded denim."
Irina
Natalie
Michelle / The Giddy Stitcher@artbyailbhe *raises fists to the air*
WHYYYYYYYYYYYYYYY
Meguey-shaped bundle of bits
just_chill (domicile second.)