@linux_mclinuxface Nice! Basically like my #Screwiverse for the #HoneycombStorageWall but for a normal pegboard.

https://www.printables.com/model/470787-honeycomb-storage-wall-screwiverse

@frequentbeef Got you covered there as well, here are adapters from #Screwiverse to legacy hex holes:

https://www.printables.com/model/785361-hsw-screwiverse-to-legacy-adapter

@frequentbeef Nice! I also find the original inserts way too tight, so I made the #Screwiverse inserts:

https://www.printables.com/model/470787-hsw-screwiverse

They are easily movable and not such a pain.

@daniel Amazing! Be sure to try my #Screwiverse inserts to connect the panels and other accessories, they are much easier to handle and remove than the defaults:

https://www.printables.com/model/470787-honeycomb-storage-wall-screwiverse

And don't make the typical mistake of mounting it wrongly: when mounted, the top and bottom is flat, not pointy and the thinner walls face to the wall, not to the front.

@teotwaki Oh, you are right! Interestingly, Printables only allows selecting the same license as the original HSW (CC-BY-NC in its variants) when making your model a remix of it. 🤔 Is that broken logic?

I don't like the NC on my #Screwiverse and would like to just make it CC-BY, but Printables lets me only do it when I remove the remix link. Bad for visibility, but probably fine legally as my models are made from scratch.