Датчик качества воздуха EFEKTA Smart Air Quality Box

Приветствую всех читателей Habr, сегодня хочу рассказать вам о моем новом интересном проекте для умного дома — многофункциональном датчике качества воздуха EFEKTA Smart Air Quality Box , работающем на протоколе Zigbee 3.0. Современные технологии умного дома активно развиваются, и одним из ключевых аспектов комфортной жизни становится контроль микроклимата. Качество воздуха в помещении напрямую влияет на здоровье, работоспособность и общее самочувствие. Если вам интересна тема контроля качества воздуха и вы хотите узнать чем закончилась эта разработка — добро пожаловать под кат.

https://habr.com/ru/articles/910330/

#co2 #tvoc #pm1 #pm25 #pm4 #pm10 #air_quality #атмосферное_давление #pressure #zigbee #zigbee2mqtt #spruthub #home_assistant #cc2530 #scd40 #sgp40 #bme280 #sps30

Датчик качества воздуха EFEKTA Smart Air Quality Box

Приветствую всех читателей Habr, сегодня хочу рассказать вам о моем новом интересном проекте для умного дома — многофункциональном датчике качества воздуха EFEKTA Smart Air Quality Box , работающем на...

Хабр

My #airQuality monitor is finlazed with a temperature and humidity sensor. You can see on the graph when I was soldering. I'm glad I'm not doing that activity very often!

I am trying to categorize the sensor readings into ranges: perfect, healthy, average, bad, and terrible. However, I am having difficulty determining the ranges and a formula to categorize them using a single sensor.

Any advice?

Check #alttext for details
#ESPHome #SPS30 #HomeAssistant #diy #AirQualityMonitoring #pm25 #aqi

I had a fun #ESPHome project today, creating an interior air quality monitor using an #SPS30 Particulate Matter Sensor and a #D1Mini. I added the sensor to #HomeAssistant, and the values look good based on ChatGPT analytics.

Next, I want to aggregate the results into a global air quality sensor with categories like perfect, healthy, average, bad, and terrible.

Of course, I need to wire this setup better.

@DesRoin there are devices / sensors, for example the #sps30 PM sensors, that supports both #i2c and #uart connections. There are two drivers, one for i2c and one for uart. i2c can be attached in various ways.
But I have no idea how you are supposed to tell linux that behind this USB UART dongle, say /dev/ttyUSB0, is a sps30 that you should talk too with this driver. There is a very simple #devicetree example that does not help at all.
Even a "your bug report sucks, go fuck yourself " would be nicer than complete silence for two months, especially when other bugs are getting attention just fine.
#raspberrypi #bugreport #linux #sps30
Why do I bother again.. #bugreport #raspberrypi #sps30 #kernelpanic
Kernel panic it is then. #sps30 #i2c