If you work with laser cut veneer covered plywood, which kind of finish do you apply to it that looks good and offers decent protection? And, ideally, highlighting any laser etching too. Varnish? Beeswax? Shellac?
So Mastodon electronics/repair shops/etc people - what is the best way to restore those rubber/graphite keyboard pads you get on many music keyboards?
I'm getting a very intermittent signal when the keyboard is scanning on some keys...
With my Linux Mint install the windows have a tiny, almost invisible scroll bar on the right. If I can get the mouse pointer in the right place, it expands to just visible but very hard to land the pointer on for scrolling.
Is there a way to make it wider so that humans can find and use it please?
Thank you.
Edit:
This has been sorted, out.
Settings, Themes, Advanced settings, Settings, Scroll bar.
It doesn't work on every scroll bar (it does tell you this) and open documents and applications may need to be closed and reopened for it to take effect, but it is a lot better this way.
See down thread for details.
Anyone know enough about the ATmega328 to know if the UART can cope with something else disabling interrupts for ~2mS...?
That sounds like quite a lot to me.
This is for handling MIDI, so I think at 31250 that would be enough for up to two complete 3-byte messages to have gone past...
Am about to pile into the datasheet, but the UART was always a bit of "mystery magic that just worked" for me...
Anyone know anything about the Boss GT-1000 pedal/thing?
Someone is having issues with its MIDI being recogised by MiniDexed and I could really do with knowing what USB endpoints it has :)
There are bespoke drivers for Windows, but I can't find a definitive comment about support in Linux...
Anyone know a good source (UK) for inexpensive ESD/anti static foam for IC storage?
Has anyone hacked the protocol for the Vadiv Name badges? Uses a windows based application to configure the display
concretedog
RC2014
diyelectromusic
Alfred Chow - Maker of Things
mattdawhit
Workshopshed