**3D printed flower pot holder (hook) “Cranny”**

Read it on my blog, it has a nicer image/text layout.

I had some pots planted with strawberries and wanted them to hang them to the side of raised beds. I ran out of metallic hooks.

So I designed and 3d printed it.

The final result (flower/strawberry pots hanged at the side of the raised beds):

The first version (without the ‘crane’ structure) was too bendy to hold the pot in place.

Printed:

While printing (Prusa’s PETG, rough mode – 0.3mm layer height, speed: 100mm/s, fan: 50%, flow: 105%). The printer bed was just big enough (22x22cm):

TinkerCad design:

You can download .STL from Printables.

Printing issues

First 2 tries were a mess. My printer just didn’t want to print PETG properly anymore. It made zits, skipped lines, … ugly in one word.

Then I replaced the nozzle (after 2 years!), re-calibrated the bed, Z-height, tightened the screws and it made all the difference. I can push the speed of my poor Sovol SV06 up to 100mms again. Only the outer layer I print with 30 mm/s.

You can see how worn was the nozzle (it supposed to be pointy, not flat):

The next issue was warping. The left edge of the magnetic metallic print bed raised a bit when PETG was cooling down. So I made this to keep it in place:

Tags: #3dprinting #garden #flower #pot

https://blog.rozman.info/3d-printed-flower-pot-holder/

#3dprin #3dprinting #flower #garden #pot

Firbolg Male Cleric Paladin by mz4250
The fuzzy-faced Firbolg Male Cleric Paladin is, in some ways, a return to form for these proud giantkin.

Material: Eco-friendly Water Washable Resin
Base: 25mm
Dimensions: 33.85 × 25.77 × 37.70mm

https://3dprinting.agency/product/firbolg-male-cleric-paladin/?feed_id=22586&_unique_id=66036d3fb12ec&utm_source=Mastodon&utm_medium=ron%40webwaves.ca&utm_campaign=FS%20Poster

#dnd #dungeonsanddragons #3Dprinting #rpg #tabletoprpg #3dprintedterrain #3dprin...