Flux Image Upscaling
@Finite52
- 5 Followers
- 38 Following
- 31 Posts
Hobbyist, Metalhead, Engineer
https://medium.com/@ctefer/the-first-key-to-writing-is-to-write-48b67a0d5cb0
"The key to writing is to write"
https://medium.com/@ctefer/establishing-program-risks-3b24156915dd
Establishing Programmatic Risks
Improving My Code Reviews
https://medium.com/@ctefer/improving-my-code-review-process-f746e5449219
Read “I went deep-diving into AI image generation, and you know what I found?“ by Chris Tefer on Medium:
I went deep-diving into AI image generation, and you know what I found?
> Porn … so much porn
Read “Jellyfin: All my Music From Anywhere“ by Chris Tefer on Medium:
Jellyfin: All my Music From Anywhere
https://medium.com/@ctefer/jellyfin-all-my-music-from-anywhere-c8006fc6dfb2
> A Journey into my rather complicated Jellyfin setup
Read “Rust, a syntactical hellscape (part 3)“ by Chris Tefer on Medium:
Rust, a syntactical hellscape (part 3)
https://medium.com/@ctefer/rust-a-syntactical-hellscape-part-3-3f7cbf757025
> I have rabble roused the Rust base. I don’t think this is a bad thing as it drives some healthy discussion, but I wanted to defend a few of…
Read “I’m a Hobbiest“ by Chris Tefer on Medium:
I’m a Hobbiest
https://medium.com/@ctefer/im-a-hobbiest-dbaccbbcfe22
> I don’t mean I’m a hobby mechanic with a project car. I also don’t mean that I’m a hobby wood worker, or a hobby watch maker. I mean that I…
Maiden voyage of my #tarmo5r . It ran for about 2 minutes before the motor sheared off the rotary gear. The part itself was modified to account for an 11mm coupler, but on top of that, only the gear teeth were holding on to the coupler. The actual part has a huge space to account for larger motor shafts but it really weakened the structure.
I'm reprinting the part with an 11mm coupler hole and 100% infill. I also closed the gap.
Learning a lot about 3d printing. I'm at the "everything goes on a raft" level. I've had too many bad print starts.
This is my latest print, and my biggest. It's an RC chassis
