DeviniusDec 14, 2024
Ist schon echt praktisch 馃槃 #3ddrucker #bambulaba1 #duplotracks
Show threadPawe艂 Szczur Apr 18, 2024

Na zdj臋ciu numer 1 leci testowy wydruk jednego kr贸tkiego toru wg poprawionego designu oraz 4 p艂ytek 艂膮cz膮cych tory lub pozwalaj膮cych budowa膰 co艣 obok nich ;-)

Zdj臋cie numer 2, to tor, kt贸ry drukowa艂em od spodu.

Warto podkre艣li膰, 偶e robi艂em wydruk bez podp贸r na ca艂ej d艂ugo艣ci oraz z niestandardowym ustawieniem "bridge angle".

Czasami brakuje mi precyzyjnych ustawie艅 bridgowania.

#OpenSCAD #PrusaPrinters #PrusaSlicer #PrusaMK4 #3dprint #3dprinting #Duplo #DuploTracks #LegoDuplo #Olsztyn #Warmia #Poland

Pawe艂 Szczur Apr 15, 2024

Tor prosty, d艂ugo艣膰 to 16LU (lego unit, 16mm) podw贸jny zwyk艂y prosty, czyli 256mm (a z wypustkami dodatkowe cm), dzi臋ki u艂o偶eniu po przek膮tnej da si臋 ;)

#OpenSCAD #PrusaPrinters #PrusaSlicer #PrusaMK4 #3dprint #3dprinting #Duplo #DuploTracks #LegoDuplo #Olsztyn #Warmia #Poland

Show threadPawe艂 Szczur Apr 2, 2024

The print came out very good. It fits Duplo tracks well, there are few minor caveats: the track is about 0.4-0.6 mm higher than original tracks (train can handle it, not sure about perfectionist me) and it鈥檚 a bit tight on connector.

#OpenSCAD #PrusaPrinters #PrusaSlicer #PrusaMK4 #3dprint #3dprinting #Duplo #DuploTracks #LegoDuplo #Olsztyn #Warmia #Poland

Pawe艂 Szczur Apr 1, 2024

I haven't posted my prints for some time. ;-)

Straight Duplo track of 12 duplo studs, equal to about 120 LU (Lego Units, one is 1.6mm).

We (me & son) need them to build looooong bridges ;-)

This one is a test run. If it works more or less ok, i'm gonna print few more.

It was generated and fine tuned from a OpenSCAD model available on Thingiverse.

I have my own brick OpenSCAD script, which generates better print models, but my script is inferior in parametriztion and it's not that easy to integreate it.

#OpenSCAD #PrusaPrinters #PrusaSlicer #PrusaMK4 #3dprint #3dprinting #Duplo #DuploTracks #LegoDuplo #Olsztyn #Warmia #Poland