Mastodawn

Someone knows of a purchasable (ready-to-use) #FOSS laser engraver? Let alone one that could be compared in features with the xTool M2?

A relative asked me and I can't think of any. ._.
#LaserEngraver #xTool #diy

Krachomantik May 2

Merch-Prototypen: Schlüsselanhänger aus dem 3D-Drucker und Lederpatches aus dem Lasergravierer. #3dprint #laserengraver

Smashing PenniesEC Apr 27

Working on two new products, that we would like to offer. These products involve Jeeps, laser engravers, ammo cans and Geocaching. Need to finish crunching numbers, before I can do too much more. #smashingpennies #jeep #newproducts #geocaching #ammocans #laserengraver

deadtom Apr 27

Engraving shot glasses

https://tube.deadtom.me/w/4n1gLQU8tadUV4d7iqewn9

Engraving shot glasses

PeerTube

13 Apr 1

Drawing Tablet Controls Laser In Real-Time https://hackaday.com/2026/04/01/drawing-tablet-controls-laser-in-real-time/
#LaserHacks #PeripheralsHacks #Drawingtablet #Laserengraver #Realtime #Usb #Wacom #Xtool

Drawing Tablet Controls Laser In Real-Time

Some projects need no complicated use case to justify their development, and so it was with [Janne]’s BeamInk, which mashes a Wacom pen tablet with an xTool F1 laser engraver with the help of…

Hackaday

Rafa Feb 26

Does anyone in Berlin have access to one of these new UV laser engravers? I want to make a couple tests on one. #berlin #lasercutter #laserengraver

isol Jan 15

My bit of kindness - the AusPost contractor who enables my AliExpress habit (which I can stop whenever I want), is always on time, always friendly, polite and professional (apart from the anecdotes about previous clients who yelled at him for being too early, or too late, or delivering to the printed address instead of magically divining their work address 🤯)
So, using cardstock (which he delivered), and coated metal blanks (which he delivered), I used my laser engraver (which he delivered) to make this:

#laser #laserengraver #packidge

rawe Dec 29

#k40 laser cutter maintenance:
1. Cleaned the air outlet from all the gunk
2. Swapped the moldy silicone rubber tubing and cleaned the pump/reservoir from whatever life forms lived in there
3. Cleaned the mirrors... not sure if I will use them again or go for the new ones, they are not exactly great.
4. Fixed the power switch that was welded permanently closed (big switch mode power supply on switched outlet = too high inrush for the poor switch

Next steps:
1. fit AA battery instead of coin cells in thermometer
2. Fit new air assist nozzle
3. fit new exhaust ducting and additional exhaust fan
4. Move webcam to inside of lid so #meerk40t can overlay the webcam image on the bed = better placement/material use
5. misc small things
6. Test run!

#diy #laser #laserengraver