9 Followers
10 Following
23 Posts
Gestern konnte man eine kurze Reaktorführung des Forschungsreaktors vom Atominstitut der TU Wien bekommen. Da musste ich natürlich unbedingt hin!

(Es wurde uns gestattet Fotos zu machen.)
#physics #nuclearreactor #nuclear
[imported from Instagram, posted in 2024]

Assistenzeinsatz nach den Überschwemmungen in Niederösterreich. Hier im Lager der Firma Miraplast in Würmla.

Bildquelle (leider nicht mehr zugänglich): https://www.flickr.com/photos/132846448@N05/albums/72177720320359398
#militaryservice
[imported from Instagram; posted in 2024]

Grießner Hochbrett im Zuge der Verlegung nach Hochfilzen.
#hiking #alps #militaryservice
[imported from Instagram; posted in 2023]

AYPT 2023!
1st place.

https://aypt.at/
https://www.facebook.com/aypt.at/
#physics #AYPT
[imported from Instagram; posted in 2023]

SYPT 2023!
2nd place.
https://www.sypt.ch/
#physics
[imported from Instagram, posted in 2023]

Physikolympiade Landeswettbewerb (Wien); zwar leider nicht weitergekommen, war aber dennoch sehr interessant.
[imported from Instagram, posted in 2022]

1 pc is never enough!
I've jst finished setting up debian on a pc I saved from getting scrapped (had to buy a new ssd because the hard drive was missing).
#computing #pc #linux
[imported from Instagram, posted in 2022]

I was able to visit the Vienna Scientific Cluster.
https://vsc.ac.at/home/
#supercomputer #TUWien
[imported from Instagram; was posted in 2022]

I finished implementing the "Nearest Neighbor" classifier. It was a fun project making use of the cifar-10 dataset (http://www.cs.toronto.edu/~kriz/cifar.html).
As expected the accuracy of the classifier is terrible with around 20%.

The inspiration for this project came from this https://www.youtube.com/watch?v=OoUX-nOEjG0&list=PL3FW7Lu3i5JvHM8ljYj-zLfQRF3EO8sYv&index=2&t=1169s Stanford lecture about image classification.
#programming
[imported from Instagram; posted in 2022]

Building a linear actuator. The M5 brass tube was much easier to cut than the M4 threaded steel rod.

The assembly shown is still in a prototype stage, there could be some issues with the rotational freedom of the servo motor that require a redesign.
#MG90S #3dprinting