paulrickardsTried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp. Results are meh. Maybe the flow rates aren’t right which leaves the gaps. I did use the iron feature on the top layer too.
That’s somewhat better. 100% infill (was 20%) and top iron at 20% flow (was 10%). Also using the TPU (85A) manufacturer settings file for Bambu P1S.
Åsa Maria Hedberg - artist@paulrickards
Are you using an open source file (stl or obj) for the stamp? Would like to make stamps too! Inspiring!
Are you using an open source file (stl or obj) for the stamp? Would like to make stamps too! Inspiring!
@AasaMariaHedberg I started with this model for the handle. Then sized a 10mm tall base that was 5mm larger than the artwork. Extrude the stamp part 2mm tall. And then the print settings in the previous posts. Have fun!
TPU Stamp by conorwalsh
Custom stamp for use with a standard ink pad.The stamp is divided into 3 parts the main stamp body, a cap for the stamp to stop the ink from drying and a replaceable section for the text which should be printed in TPU.To add text use your preferred design tool to add 5mm tall text and extrude 2mm up, the stamp can accommodate 1 or 2 lines of text. Don't forget to mirror your text before you print!