Todd Thomas May 27
Adriano
Some days are better than others
May 26 at 1:51pmWeb
Show threadDavid HaighMay 26

@adriano if it doesn't fit, use a hammer.

If it still doesn't fit, use a bigger hammer.

If it breaks, it wasn't going to fit anyway.

Show threadAdrianoMay 26
@leanlearnlead I also noticed this other meme during the writing of my toot
Show threadwaldiMay 27

@adriano And here you can see the escalation in action, including the torch.

https://www.youtube.com/watch?v=rSXit4Dat6s

Seized Solid, Leaking Bad & Cracked Welds! Bobcat Auger Power Head Overhaul! 💪

YouTube
Show threadBob TregilusMay 27
@adriano Ha ha!
Show threadAsymmetricblueMay 28
@adriano @Viss [thermos of liquid nitrogen, and a hammer],
“Won’t liquify, then F’ it!”
Show threadkernpanik 🐾 🕊️ ☮May 28

@adriano A few days ago, I had to remove an old thread-on freewheel from a bicycle hub, and I went from the first tool all the way down to the angle grinder. “You should have listened” pretty much describes my thoughts.

Didn't need the torch though. 🤭

Show threadpseyfertMay 28
@kernpanik @adriano oh, I never had these myself but once saw someone standing on the edge of the "I wasn't asking" wrench to get the thread-on off. ... Didn't come off.
Show threadrobcorneliusMay 28

@adriano

You missed out scaffolding tube over the end of the breaker bar step.

Also 'oh its a left hand thread'

Show threadPeterMay 28
@adriano Never heard of a hammer?