Mastodawn

Ok I decided to post this even though it is not mine, it is my friend's setup.

This is a 16 inch unicycle with a a brake, using a 3D printed brake mount, a self studded tyre and 45mm cranks.

And yes that is snow on the ground because this is clearly the perfect winter setup.

And people claim unicycles are not praticle! Ha… what a joke! 🤣

@ruari that 3d printed brake mount is more cursed than the time someone 3d printed a square taper to isis adapter

@timmy Everything about this setup is wrong. I studded that tyre, with metal screws. The cranks also have plastic shims to make them "sort of" fit.

@ruari how thick did you end up shimming them? i just cut some pop can and am hoping that’s thick enough at .11mm on all sides

@timmy My friend made the current shims we are using. I would have to ask him to be sure.

Nothing about this setup is recommended though. It is all kinds of insanity.

@ruari i’m just realizing that 4 shims is only enough for one crank unless they’re too thick and i need to do 2 of 4 sides