Bob FreemanI finally succumbed to a sale on a laser engraver recently. Here is my first success with my biz logo. It's a little burned, but I'll figure out the right settings. I want a nice deep etch, but without the burn fog around it. #woodworking #laserengraving #lasercutting
Will Browar 👨🏻💻@BadAlienBob you can put masking tape over it and the laser should burn through it without a problem. If you have a lot of little pieces you can use some fine tip tweezers (or an X-acto if you’re comfortable with it) to peel away the smaller bits of tape. It’s more work, but the results are a lot better than if you sand it..
Either way hope you enjoy the engraver!
Sveinn í Felli