Fuck it, that’s fine! 🙃 … And it just took me almost 2 hours.

Auto-home, create mesh, adjust knobs, repeat.

It’s really hard to level 9 points in a 3D space when you can control only 4 of the points but all of the points are on the same plane. I also have a feeling that my print bed is slightly uneven.

But the total difference of 0.119 millimeters is very much below my usual layer height of 0.2 millimeters.

… and it is only the base bed leveling. The mesh is used by the firmware to even out the layers by adjusting the nozzle height above the print bed.

#Ender5pro #BLtouch #3Dprinting #OctoPrint #BedLevelVisualizer