That's the US Healthcare Advantage!
Piranha Phish
- 0 Followers
- 0 Following
- 1 Posts
I figured it out. The issue was that the SSID cannot be hidden.
I didn’t realize that it was required to be visible as not a single reference I found stated that it needed to be. While it isn’t immediately intuitive as to why it would need to be visible, I suppose it makes sense as I believe the client is using the ESSID to associate rather than the BSSID, thus needs to be seen by the client.
I now get a response of “OK”. Now I’ll go actually try to connect the device and then disable WPS afterward.
Unable to initiate WPS
Unable to initiate WPS - Lemmy.World
I have read the documentation [https://openwrt.org/docs/guide-user/network/wifi/basic#wps_options] and googled extensively but, when I try to initiate WPS, I always receive a response of “FAIL”. Nobody else seems to have this issue, so what am I doing wrong? I only want to enable this temporarily as it is the only way I know to connect a doorbell camera [https://community.openhab.org/t/vivint-sensors/30250/24] that I obtained for free and need to “hack”. > uci show wireless | grep wps wireless.wifinet6.wps_pushbutton='1' > hostapd_cli wps_pbc Selected interface 'phy1-ap3' FAIL I have tried on both a Turris Omnia (OpenWRT 23.05.3) and TP-Link Archer C7 (OpenWRT 23.05.2). On each, and per the instructions, I installed hostapd-utils and replaced the stock wpad-basic-mbedtls with the full-featured version (I tried both wpad and wpad-mbedtls). I have 4 WLANs on each radio. I tried configuring the single WLAN of interest with the option wps_pushbutton '1' as well as setting it on all WLANs on that radio (per a suggestion I found), but same result. I’ve tried adding other wps_… options, rebooting, and everything in between, but same result. I don’t see anything relevant in the syslog, and can’t find a way to increase verbosity for hostapd. I’ve even looked at the source code for hostapd_cli [https://w1.fi/cgit/hostap/tree/hostapd/hostapd_cli.c#n768] which didn’t really help. Any thoughts?
3D-Printed replacement case for external modern