Phos5d ago
The new CAD files RackRobotics released about the supposedly soon to ship Betta Wire are a bad late April fools joke. None of this stuff looks anywhere close to ready
Show threadPhos5d ago

There are so many bearings submerged that are in no way rated for it…
With lots and lots of abrasive metal oxide dust suspended in the water…

I see no problem there at all /s

Show threadPhos5d ago
Like literally just stainless LM10LUU on (maybe?) stainless round rails right under and around the cutting zone where all the EDM swarf lands on
Show threadPhos5d ago
There are major flaws on the shafts connecting the belt pulleys to the motors. Components placed inside each other, flanges rubbing on printed parts, finger couplings being made to take up axial and radial loads, belts being made to take up axial loads…
Show threadPhos5d ago

These gantry XY connectors unsuited and unmanufactureable. It isn’t clear if the are meant to be metal, in which case they are unmachineable, or plastic in which case they are extremely thin (0.9mm walls) with only 1.9mm holding the 10mm round rails on, printed threads in every orientation, and no clear print orientation.

With the 2.6k price tag they could technically afford to SLM metal 3D print them, but o do not think that is realistic or practical

Show threadRue Mohr4d ago
@phos ? that could be printed...
Show threadF4GRX Sébastien4d ago
@RueNahcMohr @phos but it will not hold very well.
Show threadRue Mohr
@f4grx @phos If I knew a bit more about how it was used....
I like the linear bearing trap. concerned over the lack of compliant centering on it.
Apr 4 at 7:02pmWeb