RevK 2d ago
And now for a much more complicated test. #3d
Show threadThomas2d ago
@revk @LovesTha @flangey That's a scary print, hope it worked out.
Show threadRevK 2d ago
@tripplehelix @LovesTha @flangey close. May try again.
Show threadRevK 1d ago

@tripplehelix @LovesTha @flangey I'm going to try the print again.

I checked the Z-axis and it was juddering again, so did a few up/down and it seems clear. So this issue is not completely clear, which is annoying.

I'll how this print goes - more supports...

Show threadThomas1d ago
@revk @LovesTha @flangey Maybe contact the manufacturer? It may be a defect.
Show threadRevK 1d ago

@tripplehelix @LovesTha @flangey Or just order a new one and keep this for spare parts - but that is a tad wasteful, I know.

I have contacted them though.

Show threadThomas1d ago

@revk @LovesTha @flangey

Could be a good idea if you have the money. The print head and vat's are always useful and the cover if you ever crack it.

Show threadThomas1d ago
@revk @LovesTha @flangey I have about 5 vats in total and a bunch of membranes. They get holes in them so easy when prints fail and don't stick to the head. I've yet to replace the membrane, the idea scares me, hence the number of total vats.
Show threadRevK 

@tripplehelix @LovesTha @flangey Wow, the release film is not hard to replace, and I have a box with a few sheets. Did several times when this issue first came up, assuming that was the cause. Just a few (40 or so) screws 🙂

A spare vat, LCD, cover, etc, all make sense though. Odd to type "vat" and mean "vat" and not "VAT"!

Mar 26 at 1:09pmWeb