
Hard to think through the solution to this.
In the event it is the subframe, to get it fixed would probably mean a long time paying it off.
I can't just scrap it and get a banger because I need adaptions to legally drive, which would probably be about the same if not more than the subframe for what I need.
Scrapping it and being without a car means a total loss of independence since I can't navigate transport most days.
A few things that are making it a bit wtf:
someone I know who works almost exclusively on beamers has never seen a subframe fail on this model without something catastrophic happening
It's a /bit/ higher on one side, so could just look low from taking all the weight? Idk
There's still some bounce in it.
I'm not going to actually get any answers until we can jack it up and have a look or get it to a garage since I don't think our trolley jack fits under this car anyway π
@cat It just seems like the obvious answer give *waves arms in the direction of it*
But it's that or an unlikely dual failure, or just /looks/ like a dual failure.
But it's had work done in the past year where the kind of wear or corrosion necessary to cause any major failure should have been caught that'd be bad enough it'd fail while stationary
I am really sorry. π
@babe Damn, only thing I can think is that there was major corrosion. Weβd sometimes see that when I lived where salting the road in the winter was common and the salt corroded the metal.
Not having air suspension, corrosion is the only thing I can think of that would make sense. So likely one gave way and that canted the suspension on the other side forcing it to give way as well. You may have the right of it with it being subframe but Iβm hoping itβs corroded springs as thatβs at least more fixable.
At least it happened while it was parked instead of on the move? That could have been terrifying.
@monkeyninja @sangu That's looking more like the case.
There's just under an inch difference each side, so looked like dual failure, but there's only a few inches off what it looks like normally anyway, so it's probably one failed/one compressed.
Someone's kindly had a look at the model and spring seems the most likely point of failure. Will find out soon enough I guess!
This is a horrible problem to be facing. My youngest daughter uses hand controls to drive ams i constantly worry about the same thing. If her vehicle craps out it would take months to get a new vehicle properly equipped for her snd there are no rentals available that meet her needs.
@paulgatling I went from a 1.4 civic to this.
I always thought I was a bad driver, turned out a lot of it was the car was just very hard to drive. Having a car go in the direction I'm steering in, and as I told it to, was a revelation
@babe
Yes! It is amazing isn't it! The steering wheel does what it is supposed to, as does the brake and the accelerator and rather enthusiastically!
That is a big jump from the civic, especially if it had a bunch of miles/km on the clock
@paulgatling Miles!
I can fully understand keeping a car and running it into the ground. It's what I'm /hoping/ to do with this one
@babe
that is a testament to both car and driver! But I'm at the same place (mentally) with my sporty little nugget. I think only either a major wreck, theft or some natural disaster will separate us.
I'm really stoked you like your car in a similar way! Now get those struts fixed up and go warm the brakes up through some twisties!