Daniel Bohrer
After multiple times of wanting to use the plough plane and getting into the problem illustrated in the first picture, I finally invested two evenings and made an adjustable jig to hold slim stock for plough planing. Robert Weaving calls this a "sticking board" in his book "The Solution at Hand"; an additional nail through the planing stop to hold the stock in place is optional.
#handTools #handToolWoodworking #woodworking
Oct 18 at 7:28pmWeb
Show threadsatterleOct 19
@daniel_bohrer If you put a rebate on the underside of the sliding stop, you can use that to hold down the length of the stock by resting the rebate on the edge of your board then tighten the knobs.
Show threadDaniel BohrerOct 19
@satterle yes, I actually did that (that's why there's already a small rabbet on the planing stop), but the screws were not long enough to hold this stock :D
Show threadsatterleOct 19
@daniel_bohrer Didn't see the rebate in the photo 🤦‍♂️