TarnaqNov 25, 2023

Prints have a ridge

https://lemmy.world/post/8751293

Prints have a ridge - Lemmy.World

Any ideas as to what I’m doing wrong? This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge. I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

Show threadTarnaqNov 25, 2023
It may be because I paused the print to check raft adhesion. I’ll try some prints tomorrow without pausing.
Show threadBoozilla
Pausing a print usually causes me problems. I’m not sure why. Temperature, maybe.
Nov 25, 2023 at 11:11pmWeb
Show threadTarnaqNov 25, 2023
That’s what I’m beginning to suspect, other prints that have had ridges or offsets I paused as well.