@[email protected]
0 Followers
0 Following
1 Posts
Show threadTarnaqNov 26, 2023

So pausing the print appears to be the issue. I printed 3 minis today without pausing, and they all came out perfectly.

Thank you for all the responses!

Show threadTarnaqNov 25, 2023
It may be because I paused the print to check raft adhesion. I’ll try some prints tomorrow without pausing.
Show threadTarnaqNov 25, 2023
I should add that I’m using rafts and lifting the prints 5mm.
TarnaqNov 25, 2023

Prints have a ridge

https://lemmy.world/post/8751293

Prints have a ridge - Lemmy.World

Any ideas as to what I’m doing wrong? This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge. I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.