Addi compatible knitting loom by DonQuichote

Loom and machine knitting This knitting loom is especially designed to be compatible with a 22 needle circular knitting machine made by Addi. The reason for this thing is that the knitting machine does one thing fantastic, and any deviations are hard and / or cumbersome. One of the reasons that the machine is hard is that it is not easy to switch from circular knitting to back-and-forth knitting without dropping stitches. Knitting looms however, allow you to do a lot more things, including back-and-forth knitting wherever you want, but slower. For example, making the heel of a sock is hard and cumbersome on the machine, and could be far better done on a knitting loom. If only there was a knitting loom with the exact same size as the machine! Well, now there is. You can start a sock on the knitting machine, bind of with waste yarn as soon as you reach the heel location, and then put it on the loom. You then make the heel on the loom, which is much easier to do than on the machine. After you have done the heel, bind off with waste yarn again and hook the sock back on the machine to proceed to the toe. The same applies for mittens: you can do the wrist part on the machine, the thumb part on the loom, and the rest on the machine again. In short, you do the fast and easy things on the machine, and the more difficult things on the loom. Changes w.r.t. the original design I changed the cross section for better printability. It no longer starts horizontally from the printer bed, but at an angle. And off course I adapted the size to the Addi knitting machine. Also, the parameter "radius" is now the radius of the placement circle of the pegs.