Does anyone know how to configure a Cisco router to initiate V.120 ISDN data calls over a PRI?

I can successfully make a test call but I want a TCP port or session to automatically attach to this call

As it is, the B channel doesn't seem to be connected to anything. See this screenshot. Serial0/1/0 is the PRI. :23 is the D channel.

:0 is the B channel, but I think that's dynamically allocated, and I'm not even sure how to treat it as a terminal for testing. All I get is the usual command prompt.

Anyone I know have one of these bad boys?

(Or really, anything MagicBand touchpoint-enabled)

It seems like Ubuntu 24.04 started deciding that I need a MOK, despite it not being necessary for almost a year now.

What gives? This seems like a breaking change to make in a "stable" LTS release!

I'm also not physically present to enroll an MOK after reboot.

(I sign and boot the kernel directly and enrolled the key for that in UEFI. None of this stub nonsense!)

KiCAD experts:

I have a PCB that has some test points at the edge of the board, intended for alligator clips to bite on to.

But the pads extend past the edge of the board, which PCB manufacturers don't like.

Is there a way to set back the copper area from the board edge like you can with flood fills?

Relying on Google has been a complete clusterfuck

I can't tell you how much stuff has been permanently lost due to their edu rug pull