0 Followers
0 Following
2 Posts

For future reference…

The output of dmesg, with working drive and usb-sata cable:

[21697.558147] usb 2-2: new SuperSpeed USB device number 18 using xhci_hcd [21697.587491] usb 2-2: New USB device found, idVendor=2109, idProduct=0711, bcdDevice= 1.44 [21697.587509] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [21697.587518] usb 2-2: Product: VLI Product String [21697.587525] usb 2-2: Manufacturer: VLI manufacture String [21697.587531] usb 2-2: SerialNumber: 000000123AFF [21697.590092] usb-storage 2-2:1.0: USB Mass Storage device detected [21697.590736] usb-storage 2-2:1.0: Quirks match for vid 2109 pid 0711: 2000000 [21697.590984] scsi host3: usb-storage 2-2:1.0 [21699.441247] scsi 3:0:0:0: Direct-Access USB3.0 high speed 2210 PQ: 0 ANSI: 6 [21699.441988] sd 3:0:0:0: Attached scsi generic sg2 type 0 [21699.442809] sd 3:0:0:0: [sdc] 468862124 512-byte logical blocks: (240 GB/224 GiB) [21699.443369] sd 3:0:0:0: [sdc] Write Protect is off [21699.443382] sd 3:0:0:0: [sdc] Mode Sense: 2f 00 00 00 [21699.443975] sd 3:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA [21699.447303] sdc: sdc1 sdc2 < sdc5 > [21699.447882] sd 3:0:0:0: [sdc] Attached SCSI disk [21704.928734] EXT4-fs (sdc1): mounted filesystem with ordered data mode. Quota mode: none.

The issue is now resolved.

  • Replaced boot ssd for a new one.
  • Installed Truenas on said ssd.
  • Imported config/db.
  • Unlocked encrypted datasets on data drives.
  • Really straightforward with Truenas. Thanks to those who took the time to reply 👍

    Well, I did mention it was a SSD in the post.

    As for backups…
    The disks containing the important stuff are higher spec SSD’s.
    The data is backed up on 3 different drives - one offsite. So not really worried about dataloss at this point. And I have a fairly recent backup of the Truenas config/db.
    The choice to not backup the boot drive, was made to save some money.
    Just trying to figure out if a reinstall of Truenas on a new drive is the only option left. 🤷‍♂️

    Output of journalctl is almost same as dmesg:

    dec 04 05:22:58 mx kernel: usb 2-1: new SuperSpeed USB device number 17 using xhci_hcd dec 04 05:22:58 mx kernel: usb 2-1: New USB device found, idVendor=2109, idProduct=0711, bcdDevice= 1.44 dec 04 05:22:58 mx kernel: usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 dec 04 05:22:58 mx kernel: usb 2-1: Product: VLI Product String dec 04 05:22:58 mx kernel: usb 2-1: Manufacturer: VLI manufacture String dec 04 05:22:58 mx kernel: usb 2-1: SerialNumber: 000000123AFF dec 04 05:22:58 mx kernel: usb-storage 2-1:1.0: USB Mass Storage device detected dec 04 05:22:58 mx kernel: usb-storage 2-1:1.0: Quirks match for vid 2109 pid 0711: 2000000 dec 04 05:22:58 mx kernel: scsi host3: usb-storage 2-1:1.0 dec 04 05:22:58 mx mtp-probe[31054]: checking bus 2, device 17: "/sys/devices/pci0000:00/0000:00:14.0/usb2/2-1" dec 04 05:22:58 mx mtp-probe[31054]: bus: 2, device: 17 was not an MTP device dec 04 05:22:59 mx mtp-probe[31084]: checking bus 2, device 17: "/sys/devices/pci0000:00/0000:00:14.0/usb2/2-1" dec 04 05:22:59 mx mtp-probe[31084]: bus: 2, device: 17 was not an MTP device dec 04 05:23:20 mx kernel: usb 2-1: reset SuperSpeed USB device number 17 using xhci_hcd

    This cable has connected fine to previous ssd’s.
    Maybe the drive just had a typical ssd reactive failure 🤔
    (Disk Manager is just a gui mount tool shipped with mx.)

    TrueNAS boot drive dead? - help

    https://lemmy.world/post/22722878

    TrueNAS boot drive dead? - help - Lemmy.World

    Hi all! I’m stuck with a problem on my TrueNAS server. I suspect the boot drive is dead, but I don’t know how to proceed to get it back up and running. My setup: -HP Compaq 8000 Elite SFF with 8gig ddr3 -TrueNAS-24.04.2.5 -Boot drive: Kingston SSD A400 240GB -Data drives: 2 X Kingston SSD DC600M 960GB Today i noticed that my Truenas was offline and I couldn’t ssh into it. The nic lights were not showing any activity. After a few boot attempts I hooked it to a monitor and keyboard. No boot media detected. The checked in the bios and the data drives are detected but not the 240GB boot drive. So I pull the boot drive out and hook it to my Thinkpad running mxLinux. I have a USB to SATA cable, that I’ve used before to troubleshoot drives. The drive is not showing up in Disk Manager. Output of dmesg -w when hooking up the drive is as following: [ 2369.520731] usb 2-1: new SuperSpeed USB device number 9 using xhci_hcd [ 2369.547175] usb 2-1: New USB device found, idVendor=2109, idProduct=0711, bcdDevice= 1.44 [ 2369.547194] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [ 2369.547202] usb 2-1: Product: VLI Product String [ 2369.547208] usb 2-1: Manufacturer: VLI manufacture String [ 2369.547213] usb 2-1: SerialNumber: 000000123AFF [ 2369.549433] usb-storage 2-1:1.0: USB Mass Storage device detected [ 2369.549917] usb-storage 2-1:1.0: Quirks match for vid 2109 pid 0711: 2000000 [ 2369.550061] scsi host3: usb-storage 2-1:1.0 Been trying to resolve this for hours with google but to no avail. Any help appreciated where to go from here. Thanks 🙏

    I use names from movies, TV-shows or games.

    miyagi (pfSense, Fujitsu Futro) kratos (Main server) boy (lxc container on main server) nicknack (ThinkCentre M93p tiny) nas-t (Truenas) cosmo (Desktop PC) To name a few. Easier to remember when they have silly names 🤷

    Why was he in prison again…?
    What if you drag the window to the corner or the side of the screen? Does it snap then?
    Respect 🤌