cpresser

@cccpresser@chaos.social
768 Followers
246 Following
2.8K Posts
Hardware Hacker
does stuff with and for #KiCad
DSGVO-Ultra
Websitehttp://ca.rstenpresser.de/
BLÅHAJFriend
Licensehttps://ca.rstenpresser.de/LICENSE.txt

My muon detector is setup at #gpn23
You can find it on the sticker table.
There is also a poster nearby explaining how it works.

(Please don't steal our scope!)

The codekarte does not know where the wagen is at all times.
Who needs a Rolex if they can have the Würth Elektronik 7 Segment watch?
Instead of sharing successful projects, here is a fail instead.
At work I killed this FPGA module by changing the 1.8V supply rail. The goal was 1.2V, but I took the wrong feedback resistor and put about 10V into the Vccio rail. 🪦RIP
#NameThatWare full picture with details

Found a picture for another #NameThatWare challenge.
Since its quite easy for people that have opened similar devices, the first image is only a section of the full picture. The 2nd post shows more of the thing.

As always, try to explain your guesses. What is your deduction based on? Why can't it be another similar thing?
And hide those words behind a CW to not spoil it for others.

If you are familiar with this kind of device, try to figure out the specific make and model.

I present: (Keyless Chuck)-Key

drilling through 3.2m of stainless aparently tightend it a bit much..

Aus aktuellem Anlass:

"Remember kids, the only difference between Science and screwing around is writing it down."

It is done

Das @ztl heute auf der #makeit in Saarbrücken

https://make-it.saarland/

#Makerspace

×
It is done
Das gekonnte Auge erkennt das Kerzenlicht: es gibt gerade nen straßenweiten Stromausfall
@tyalie did you end up vectorizing it yourself completely? very cool result!
@eloy yes traced it by hand. That was the right choice in the end as it allowed me finer controll over the stiching as if I would have taken an autotraced path or something.
I'll upload the file later, but it is incomplete as it only contains what I needed.