You can try seeing if you can set the speed/duplex of NIC/ports manually if auto-detection keeps getting it wrong.

Unifi I like the APs for mesh & multiple SSID+vlans but I keep them on dedicated vlan with zero internet access because I don’t trust that I properly followed instructions to disable opted in analytics/telemetry. The mgmt software is alright but new UI wastes a lot of space. The PoE switch was alright until it stopped being able to keep a config last year. USG router I kept less than a year because it was too slow with any useful features enabled. I’ve glanced around at replacement APs here & there but pretty much waiting until I have more wifi 7 compatible devices and that’ll be another couple years.

My first zigbee device was Sylvania (73685) rgbw led strip. On it’s own it worked fine but once I started trying to add sengled zigbee bulbs I kept having problems with pairing the bulbs or keeping them connected. Zigbee uses 2.4ghz so I thought maybe interference so lowered power output on wifi AP 2.4ghz band & even turned it off for testing but didn’t help. I think I read somewhere that sylvanias caused that problem. I unplugged sylvania led strip, reset & rejoined everything else and had zero problems. Tried to add the sylvania back in and disconnect problems came back after awhile. It was past the return period so now I keep it unjoined and plugged into a zigbee smart outlet. I sometimes have to remove power from it to join new devices or when I restart zigbee controller. Currently have mix of sengled bulbs, thirdreality plugs, sonoff plugs & sensors, and single aqara tvoc all working together fairly reliably.

What are max print speed and volumetric set to?

For some filaments (silk PLA) I’ve had to slow things down (120mm/s max print speed and 10mm3/s max volumetric speed) or it comes out horrible. Only used 0.4 nozzles so far though.

I’ve bought a few Gmktek Intel N97 mini-pcs on Amazon (US) for around $200 usually. So far I’ve only used them for htpc @ 1080p but N97 GPU has a higher boost than N100 GPU so I imagine should do alright for lots of emulators too.

Their project timeline being really short combined with a really low “flexible goal” of $69,780 doesn’t give me a lot of confidence in it releasing or shipping on time if it ever does.

On ‘Startup’ section, what options are available for ‘Boot Mode’ ? May want to try using something other than Quick during OS install. Should be able to change it back afterwards for faster boots.

Star Trek ENT season 4 episode 10 “Daedalus” has the transporter inventor on board for an experiment. I’d like to see more about initial development too.

Slicers for FDM are open source and lots of forks. The built-in printer profiles vary a lot but can be created from scratch. You can find lots online to use as examples too. I currently use Cura, Prusaslicer, and Orcaslicer.

I’m more interested in printing plastic than tuning/upgrading the printer itself so I recommend a printer with automatic z-offset and bed leveling. Basic maintenance tasks such as cleaning, oiling, and greasing will need to be done on occasion no matter the printer. Beyond that I’ve only done simple retraction tuning.

I started with Elegoo Neptune 3 Pro. Klipper firmware upgrade improved speeds a lot. It wasn’t bad for a budget printer but lack of automatic z-offset can be frustrating so I replaced & gave it away to friend. Replaced it with Creality K1 which was a lot easier to get started with thanks to automatic z-offset calibration. Output quality is good but to get better would require upgrades + tuning. Been saving up to replace with Bambu Lab P1S combo so I can also do multi-color printing.

Hot Wheels has Marvel series of cars too and took picture of this “well known” one recently.