Req: newcomer guide to SLA printing?
https://lemmy.today/post/14652076
Req: newcomer guide to SLA printing? - Lemmy Today
I just received an unexpected SLA printer from what I had assumed was a failed
Kickstarter for the “Coolsiga FinderOne” or C1 or Classic. The manual is clearly
intended for someone who has some context, but my past experience has been
entirely FDM based. I’m not claiming it’s a good manual by any stretch of the
imagination, nor am I confident that it will work – but is there an “Dummies
Guide to SLA Printers” I can read through to at least know what it’s talking
about?
First level printing too tall - Lemmy Today
Hi - Tenlog TLD3-Pro, printing with branx new Overture PLA+, printing an
OpenSCAD exported STL sliced with Cura 5.7.1 (most recent as of yesterday). I’m
printing first level at 0.3mm thickness, but the print is irregularly too thick
in height – and not by a little bit, a lot. I’ve lowered the temperature to 190.
I’ve physically lowered the bed to the point that the skirt didn’t print, then
raised it just barely back. I’ve reduced the flow rate to 85%, and I’m still
getting the same results. I’ve lowered the build plate temperature, no change.
The skirt might be a tough high in spots, but I’m ending up with the first level
of a prime tower that looks like this. Any ideas? What else can I try?
