Esim to sim cloning?
- 0 Followers
- 0 Following
- 1 Posts
Motherboard swap!
Motherboard swap! - Lemmy.World
After tuning my vref, the printer was missing steps still. I pulled the trigger and am swapping from the 4.2.2 to the 4.2.7 creality board to see if that resolves the issue. While i was in there, I figured I’d put another z axis motor on there. Do you guys have any recommendations on firmware or should I just stick with creality’s?
Clogged nozzle?
Clogged nozzle? - Lemmy.World
Sorry for the potato quality picture. I really thought we were over this since I tune the vref, but I guess not. Do you guys have any idea why my info would look like this but all the walls on the printer are fine? I assume if it was a clog nozzle it would be inconsistent.
Framing cleaning help
Framing cleaning help - Lemmy.World
I apologize if this isn’t the correct community ask, but i was hoping for a bit of help getting this frame cleaned up. My wife and I picked this piece up today. There’s some water damage and i’m wondering what the best way to clean the fabric matting would be or if we should get it replaced. For those curious it looks like the artist is Edward Aldrich. We think its an oil painting and from the date we’re guessing its from 97. Thanks everyone! P.S. I took a look through the community and the art here is amazing!
Thank you!
Thank you! - Lemmy.World
Thank you guys for pointing out the vref issue in my last post! I got it adjusted, and they were all fairly high so now they should be dialed in. While I was in there, I figured I should probably calibrate the extrusion steps as well. I’ve got a couple larger projects coming down the pipeline. But if I can go off of this cube, I think I’ll be in good shape.
The art and the artist
The art and the artist - Lemmy.World
I left the print over the weekend and I came back to spaghetti. It looks like something, caused the printer to push the print off its base like it was a poorly leveled bed? I still have to watch the camera footage to see what failed, but I hope you guys get a chuckle out of the spaghetti monster like I did.
Rudder build!
Rudder build! - Lemmy.World
A few of you may remember my post about the back end of my boat falling off and wanted to say thank you for all of your advice/encouragement! I started building a new rudder a couple weeks ago and am probably a couple weeks out from getting it finished up. The hole in the back end has been sealed up and I built a much stronger mounting point than the original system. I found a template of my boats rudder and modeled a copy then 3d printed the core. Between the fiberglass and the rods I’ve added for rigidity, I’m hoping it works out well. It may be coming up to October, but I think I’ll get at least one test run before the season ends.
First sail of the season
Which slicer do you use
