FozzTexxPrototype of #TRS80 CoCo #FujiNet which uses the cartridge bus –and not the CoCo RS232 serial port– booting up the FujiNet CONFIG program. Shows the splash and goes into the menu! The prototype board uses a PicoROM wired direct to the bus, all IO is sent out over the USB port. This is the same technique currently being used by the MSX FujiNet prototype too.
Irenes (many)@fozztexx the k'nex monitor stand is cool, too
@ireneista The whole rack is made of K'Nex. https://mastodon.fozztexx.com/@fozztexx/115877087253788766
FozzTexx (@[email protected])
Attached: 2 images "Refactor" number eight? I don't know, I'm losing count. At this point my fingers hurt so much it's hard to type. Everything seems to fit, but I haven't tried to hook anything up yet. More than likely I'm going to have to rebuild a few more times to get the cables plugged in. #RetroComputing #VintageComputing
@fozztexx oh that is ridiculously cool!