nieceandtowsWhat does the bed mesh in Fluidd show? My prints are good, nothing to complain about, but I see the bed mesh doesn't look so good.
AverageGoobWhat I have used as a rule of thumb is to keep the difference below .2, .6 is a huge difference in my mind and is making your printer work much harder to compensate for the large difference.
Klipper with proper mesh and a reliable Probe on a fixed bed can handle 1mm range without any issues at all.
how would I do that?
either have something like KAMP handle your meshing adaptively before every print (takes more time every print, will work even with different bed);
or by having a fixed bed without any adjustable screws/etc., creating a proper bed_mesh (eg bicubic with an amount of probe_count on the higher side) and loading it in your print_start before every print. (will always work aslong as the bed/setup stays the same. Gotta remesh when you change beds)