I still think rear signaling could be improved dramatically by using a wide third-brake light to show the intensity of braking.

For example – I have seen some aftermarket turn signals which are bars the width of the vehicle, and show a “moving” signal starting in the center and then progressing towards the outer edge of the vehicle.

So now take that idea for brake. When you barely have your foot on the brake pedal, it would light a couple lights in the center of your brake signal. Press a little harder and now it’s lighting up 1/4 of the lights from the center towards the outside edge of the vehicle. And when you’re pressing the brake pedal to the floor, all of the lights are lit up from the center to the outside edges of the vehicle. The harder you press on the pedal, the more lights are illuminated.

Now you have an immediate indication of just how hard the person in front of you is braking. With the normal on/off brake signals, you don’t know what’s happening until moments later as you determine how fast you are approaching that car. They could be casually slowing, or they could be locking up their wheels for an accident in front of them.

I see a lot of those on trucks here in the south. Good for when you are towing shit so people can see around all your junk in the trailer.

Does your state not require good lights on the trailers? I just built a new trailer last year, I was required to have full working brake and turn signals along with running lights, but I went the extra step and included more brake/turn lights on the front and rear of the fenders, along with reverse lights plus four marker lights along each side. Trailers are hard enough to see, I didn’t want to make it harder for anyone by just sticking with the bare minimum.