MagrathSep 1, 2023

3D Printable Wire Duct

https://lemmy.ca/post/4389262

3D Printable Wire Duct - Lemmy.ca

Here is my first published print. It’s 3D printable wire duct. Working in industrial environments I’ve always leaned toward using wire duct for wire management. I couldn’t find any I liked so I set out to make my own. I’ve published it on Printables. You can find more details there about the print. I’d appreciate any feedback you can give me. https://www.printables.com/model/567318-wire-duct [https://www.printables.com/model/567318-wire-duct]

Show threadsaplyngSep 1, 2023

I don't think I've ever seen one of these o:

So it's like a hallway for wires and the bars can pass them through should you not want to go the whole length?

Show threadHotchip

Commonly found in electrical control cabinets to clean up the point to point wiring (between plc, relays, buttons, etc) usually found with the cap missing and wires strewen around.

The cap pops off and the breaks in the duct allow wiring on either side. Done right it makes a panel look clean and generally makes diagnosing easier.

Sep 1, 2023 at 4:26amWeb
Show threadPhaseLockedSep 1, 2023
You neglected to mention that half of the wire tags are also missing, random extra cables that don’t seem to go anywhere, and the book of prints inside the door have never been updated!
Show threadHotchipSep 1, 2023
I didnt want to scare the fellow ;)