jacquelines 🌟someone should make a jlcpcb bingo card. so far i’ve got
“asked to confirm there’s no copper in my gerbers”
and
“incurred the fee for too many slots”
VE7FIM"the spacing from cutout to board edge is too narrow which may be broken"
"the copper trace seems not regular copper lines"
"there is bug in EasyEDA"
"the v-cut line will cut the fiducial mark"
"can we add 5mm edge rails on both sides to proceed"
"board size of your order exceed 200*250 mm, there may have several bad boards after production"
"your file is 2 layer, but the order info shows that it is 4 layer"
"please enlarge the space between indicate holes at least 0.25mm"
Also, when they mess up:
"We found that there were copper leakage on the edges of several boards. Sometimes it is unavoidable and we will pay attention to this issue in the future. We hope you can understand."
@ve7fim i am certain that you specifically have a flag on your account that just says "yo this they/them does some weird shit"
Most likely... They've been really good with all my weirdness. I only had to cancel two designs out of > 700. Those ones were just too weird, even for them.