Now here -> @nebogeo
dave griffiths
@nebogeo
- 11 Followers
- 98 Following
- 57 Posts
games, magic, livecoding, free software, weaving as computational matter. http://thentrythis.org PGP: E785D3B5
ultrageraniumAn overdue announcement that felt into the cracks of pandemic times 🥲
In 2020, LIMA (https://li-ma.nl) commissioned @monoskop and @jules to find a way to docu/archi/preserve Naked on Pluto (2010) from @l03s @nebogeo and myself.
The result can be found at https://monoskop.org/Naked_on_Pluto
The amount of work they put in to keep the discourse/intention around the project accessible and alive is just incredible. You can read about the process, challenges and their approach on this page:
https://monoskop.org/Naked_on_Pluto/Preservation
Thanks again so much ❤️
The next instalment in FoAM Kernow talking with Sam Gyimah MP: Minister of State for Universities, Science, Research and Innovation via Sarah Newton MP https://fo.am/blog/2018/10/05/reply-foam-kernow-sam-gyimah-mp-minister-state-universities-science-research-and-innovation/
Reply to FoAM Kernow from Sam Gyimah MP, Minister of State for Universities, Science, Research and Innovation.
<p>Our letter to <a href="https://fo.am/blog/2018/08/16/open-letter-sarah-newton-mp/">Sarah Newton MP</a> for Truro and Falmouth was forwarded to Sam Gyimah MP, the Minister of State for Universities, Science, Research and Innovation.</p>
First actually fully cut, drilled and milled PCB - 0.5mm traces, 0.5mm endmill - a pattern matrix sensor board.
A CNC success, finally! 0.5mm milling drill, 0.135mm depth, voronoi regions rather than tracks, paper based PCB rather than fibreglass (smells better too)
I <3 cnc. Drill bit: 1mm, mill bit: 0.8mm, mill depth 0.235mm, feed: 45mm/min, track width 1mm, track clearance 1mm - with a test IC that could actually be soldered.
First attempt at CNC milling a circuit board - getting it level seems to be one of the tricks to solve.
