@daryll that is genius
This is not the account you are looking for.
I can go about my business.
Move along.
Matthew
@mutthew
- 22 Followers
- 287 Following
- 316 Posts
You don't need to see my profile.
This is not the account you are looking for.
I can go about my business.
Move along.
This is not the account you are looking for.
I can go about my business.
Move along.
@dennis the adhesion was solid. Both prints were still stuck to the bed when I stopped the printer. You can see the breaks in the base of the helix on the base. Unless I am not understanding your meaning.
I had not thought about the infill. I will check into that!
#3dprinting my Klipper-ized Sovol SV06+ keeps knocking down my prints at around the same height. It is almost as if the machine starts to forget at what height it is at and just runs into the prints for fun.
Any assistance available?
@kokurya gonna need the. STL on that one please
@treyfordham Filament runout sensor?
Simulating Air Flow For 3D Printing
https://hackaday.com/2024/08/25/simulating-air-flow-for-3d-printing/
@alper did it make it?
Is it bad that I have been going full on lavishing attention on my #SOVOL #sv06+ with upgrades and enhancements and then after seeing the #Prusa #MK4s appear want to regulate it to some corner to gather dust?
@EddiKat and the results are?
Finally after many attempts and failures that helped pave the way... I was able to #3dprint a chain necklace for my wife!
https://www.printables.com/model/673123-u-chain-print-in-place-necklace
I had to put a brim of it, enable supports, use blue painters tape to get better adhesion, adjust my parts cooling fan... I think this was my most difficult print ever.
