Finally got the 3D printer back up and running just in time for #PokemonGoCommunityDay @7pidgeys events will have coins at them again and other 3D printed goodies!
| Home Community | @7pidgeys |
| Friend Code | 7350-4276-4789 |
| Discord | @FocusForte |
David Jeffers 
@forte@social.pogo.community
- 64 Followers
- 111 Following
- 119 Posts
I Finally figured it out!!! It was the cooling fan. I had it set to turn the cooling fan on after the first layer at 100%, which for this print job was causing the coin to cool too quickly and curl.
Set it to wait till the 5th layer and it's working fine now!
These came out pretty awesome if I do say so myself!
@djravenwolfe made a small tweak, I added a rate limit, and also a function to tag the pokemongo group page!
@djravenwolfe got the auto-cross-poster made! So the basic pogo news sites are here, at least in spirit lol. Here's hoping a few of them decide to take take over their copycat accounts.
I'm actually getting pretty impressed how much I can crank the speed up on this thing. But I'm starting to get really annoying because no matter how much I slow it back down, I keep getting this issue for the first layer starts peeling and curling off the bed.