I have a question for the #tinkerer community. This board is from an Argus 3 Ultra camera which has a crumbled USB connector (known issue). The camera is fine and has been replaced under warranty so I'd rather not throw this one out as a result without trying a repair.

I can't find a replacement board vendor so my only option is to replace the USB port entirely. I've never done this though, my question is - is it feasible to replace? I assume I need to desolder it from the top and bottom? Does anyone know of a UK vendor that sells the same USB C ports, or is it the kind of generic connector I could buy and adjust from any electronics hobby shop?

Do I need a special solder tip for this sort of work? I've got a basic gas powered iron with some small tips but I can't recall their sizes.