Dropping by my friend's place to pick this up and two more prints. Let's see how things fit. Here's a hint: #n64 #nintendo64

Need to adjust the sizing a teeny little bit for the 3.5mm jack and USB-C ports. Got the sizing of the opening for the UTP port totally wrong.

The quest continues... #n64

3 hours later.... Really need to rethink how to design for 3D printing...

Well, everything fits now. Stilll don't know if the 3D model ismok or not as I have had to trim so much from the print... Next Post will be one where you can see it connected to the "N64"... #n64 #nintendo #retrogaming

And here it is. It is an AV plug for the iQue. 3.5mm jack can be used to connect a composite cable to, USB-C is for power (5V) and the RJ45 socket can be used to add extra controllers for multiplater and s-video. #ique #nintendo #n64

Cut the XBOX av connector to size to test fit as well. After that it is back to the drawing board to make changes. The whole thing is a bit on the big side and it looks like I can make it a bit shorter. Oh and also made a mistake and the RJ45 socket is not centered. #n64 #ique

Fits, kind of. Will need to reduce the height of the hole of the connector a little. Plenty of space on the inside, so I can reduce the length overall as well. #n64 #ique

Friend managed to print the adjusted model, just in time before he goes on vacation tomorrow. Shortened on both ends and also printed in a different orientation so hopefully it will be a lot less work to remove the supports. #n64 #ique

The shortened version still has enough room for everything inside, so that's good. But the opening for the usb-c connector is not big enough and the RJ45 hole too. Everything else fits fine.