Jimmy B. 

I've started dipping my 3D #resin prints into hot water for about 10 seconds after washing them. This seems to dramatically assist in removing supports from the print. It also seems to leave less marks from the supports. (1/2)

#3DPrinting #Elegoo #3DPrinter #ResinPrinting #Saturn4Ultra #tips

Jun 14, 2025 at 6:50pmWeb
Show threadJimmy B. Jun 14, 2025

I've also started to use my air duster to dry the print before curing it. The ensures the alcohol or whatever cleaning solution I was using when tidying up the print has evaporated or been removed.   (2/2)

#3DPrinting #Elegoo #3DPrinter #ResinPrinting #Saturn4Ultra #tips