Roy GreenhiltFeb 17, 2024

#3dprinting Tip o the Day. Obvious to most folks, I'm sure, but I had to test it.

The #BambuLab printers can do multiple colors - yay on that, but the slicer isn't smart enough to know that it could print several layers in one color, then switch filaments, then do multiple layers in the other - with clearance to navigate around printed stuff.

Which means the printer changes filament every layer.

Okay for small prints, but moving forward, I'll print each component separately.

#makers

Show threadBenjamin Monjoie
@roygreenhilt There is an option in Bambu Studio to print each object one after another rather than layer by layer. It will even show you the real clearance needed. You should try that
Feb 17, 2024 at 7:51pmWeb
Show threadRoy GreenhiltFeb 17, 2024

@Xzan OH MY GOD. I had no idea. There it is. Okay, I'm going to let this job finish, then try this.

You are my hero today, thank you!!!

#BambuLab #3dprinting #mastodonisawesome