The #Gameboy camera works fine, I might need to clean the lense, though. To gain access to the images, I ordered a Shawazu GB Dumper kit and soldered it today.
Only thing I changed was using a genuine Pi Pico instead of the clone that was in the #solderingkit.
I had to resolder a few of the connections of the level shifters, since they usually are soldered with through hole pins.
Also, I used green enameled copper wire for the two jumper wires.
Here the shop I ordered it from: https://retroreiz.de/shop/werkstatt/ersatzteile-gameboy-classic/shawazu-gb-dumper-kit-fuer-gameboy-spiele-cartridges-diy-version/
#soldering #RaspberryPiPico #RetroReiz

Second #soldering exercise: #SMD parts. They were very fiddly and I think I'll stick with 1208 or 0805. Those 0603 resistors were too small for my taste. Also, I had two little errors at the first go, one of the 0603s and one pin at the SOT23-5s weren't soldered properly, leading to two LEDs not lighting up.
It's this kit: https://www.ehajo.de/products/smd-lotubung-1206-0603-ics
#solderingkit

Continued with the second #PCB, the #synthesizer #shield.
The only things I changed were adding a socket for the #OpAmp and JST connector for the speaker.
I oversaw that this caused problems with the cardboard case, so I had to cut some holes. But I'm no fan of cardboard anyways, so I don't think I'll use it.
#Arduino #ArduinoUno#soldering #solderingkit #audio