i4cy 📌3D Printed these rather orange looking end panels, designed using #Sketchup and printed out using #Repetier.
#3dprinting #3dprinter #geeetech #prusa #reprap
[14/04/2020]
Kisho DerrekIt's alive (again)!
#Arduino DUE + Smart #RAMPS +#Repetier replaced with Arduino #Mega2560 + RAMPS 1.6 + #klipper
#BLTouch replaced with inductive sensor (not sure how precise it will be but we shall see).
Short circuit on hotbed eliminated (it looks like it was fallen LED with it's wires).
Damaged extruder cable replaced.
Štěpán ŠkorpilI finaly upgraded my 3D printer:
1️⃣ switched from #Repetier to
#Marlin firmware
2️⃣ replaced heat bed thick PEI foil mounted by paper clamps by magnetic PEI covered steel sheet
3️⃣ replaced defective extruder termistors
#DnesBastlím #3DPrint #DIY #Upgrade
1️⃣ switched from #Repetier to
#Marlin firmware
2️⃣ replaced heat bed thick PEI foil mounted by paper clamps by magnetic PEI covered steel sheet
3️⃣ replaced defective extruder termistors
#DnesBastlím #3DPrint #DIY #Upgrade
Ronal Forero 🇻🇪 🐧