I revived our very small pool today because it's starting to be hot outside.
One of the O-Rings had disintegrated and i already hat a trip to the hardware store today and it was closed by now.

So, I just loaded up the, at least 5 year old, Ninjaflex filament in my #prusamk4 and #3dprinted a new one in less than 10 minutes including "cad" (if you can call making 2 concentric circles that :) )

That's what i love about #3dprinting

I used the part cancellation feature for the first time today and I'm pretty happy about how well it worked. Not having to cancel the whole print saved a lot of time and material.

#3DPrinting #prusamk4

Wieder was erledigt. Jetzt neu: MK4S

#3ddruck #prusa #prusamk4 #prusamk4s

Today I’ve advanced to a next level of 3D printing fan club.

Yesterday, when printing a part for my son’s base the printer went awry and messed it up. I’ve stoped it in the middle of printing. I’ve then tried a tiny few minute model, and it failed.

I’ve decided to run printer calibration and to my surprise it failed. I’ve rerun it 3 times with same result: Y-axis cannot be calibrated.

I’ve spend some time searching and it seemed that a Y-axis belt may be incorrectly fastened. I’ve used Prusa app to check it, but it seemed good.

I’ve been wondering what else may be wrong and had an “aha” moment and decided to check all screws. That’s how I’ve found out that the screws on this little piece have loosen themselves and were causing a slip when an engine was trying to push the printing bed really fast.

Now it works and I can go back and print the joints ;-)

#olsztyn #3dprinting #fatherhood #prusa #prusamk4

Anyone know why the middle 80-90% of my prints are like this? It's all ripply and rough.

Guessing:
- warped print sheet
- uneven heating or cooling
- printing too hot

Printer: Prusa Mk4
Filament: generic black PETG

#3dprinting #prusamk4

RT from PrintHue (@PrintHue85)

Colosus is finished, thank you all for huge support. Hope you like the result as i do.
Filament: PETg filament
Printers: MK4
#pokemon #kids #3dprinting #3dprint #3dprinter #3dprinted #prusa #prusa3d #prusamk4 #mk4 #bulbasaur #puzzle #huge #sanding #gaps

Original tweet: https://twitter.com/PrintHue85/status/1849466951292097023

RT from PrintHue (@PrintHue85)

Bulbasaur growing up, body head and back complete.
Filament: PETg filament
Printers: MK4
#pokemon #kids #3dprinting #3dprint #3dprinter #3dprinted #prusa #prusa3d #prusamk4 #mk4 #bulbasaur #puzzle #huge

Original tweet: https://twitter.com/PrintHue85/status/1847703371471298670